Soils

From Living Building Science

Purpose of Study

Background

Methodology

I. Materials

  • Curly stakes/landscaping stakes
  • Tape measure
  • 1 m string
  • Paper bags – for collecting soil samples initially
  • Ziploc bags – for storing soil samples in freezer (make sure they are well labelled)
    • Are there biodegradable options available?
  • Soil corerGNSS device
  • Nitrile gloves
  • Ethanol (80%)
  • Paper towels
  • Bucket
  • Scrub brush for cleaning between samples
  • Cooler and freezer packs

II. Sampling Preparation

Fig. 1 - Construction plans for the Eco-Commons. Locations marked in yellow are "scraped" areas, while locations in gray are "original".

One of the primary Piedmont regions in the Eco-Commons (Labelled as ____ in Fig. 1) was selected for analysis this semester. To accurately account for differences in soil composition as a a result of construction practices, the sampling points were selected from two different areas within the region, with areas retaining the original soil labelled as “original” (OG; areas marked in grey on Fig. 1) and those where the top 10” of soil were scraped away labelled as “scraped” (SC; areas marked yellow on Fig. 1). Within each area of either OG or US soils, ten sample sites were randomly selected by approximating photographed construction patterns in Google Earth (Fig. 2 and Fig. 3), with sites only being selected if they were approximately 10 meters away from another. If a site was within 10 meters of another site, it was excluded and a new randomly selected point was selected.

III. Field Sampling

IV. Sample Drying

Samples were air dried on 18 March 2022 in Room 2-66 at the Gilbert Hillhouse Boggs Building. Counter tops were first cleaned with 70% ethanol. Container lids were subsequently cleaned using the cleaning procedure below:

Rinse with 70% ethanol

Rinse MiliQ water

Scrub with Alconox soap

Rinse with MiliQ water

Rinse with 70% ethanol

Following one hour of air drying, tape was used to visually separate the container lid into two sides and paper towels were added to the container lids to hold the soil on top of the container. Soil samples were then added to the paper towels and roots and stones were removed as recommended by Cong et al. 2015. After air drying for three days, soil samples were prepared for geochemical analyses.

V. Geochemical Analysis

The geochemical analysis of the soil cores included two phases. In the first phase, soil samples were packaged and delivered to the University of Georgia Cooperative Extension for an extensive geochemical analysis by the UGA Soil, Plant, and Water Laboratory. Each bagged sample was brought to the county UGA extension office and submitted, along with the corresponding submission forms that include address, plant grown in the soil, sample numbers, and county code. For shipping efficiency, the bags were assorted into soil sample shipping boxes at the office. The corresponding soil analysis included a routine test (testing for soil pH, lime, extractable Phosphorus, Potassium, Calcium, Magnesium, Manganese, and Zinc) and a more advanced test (testing for Sodium, Iron, Copper, Chromium, Molybdenum, Nickel, Cadmium, Lead, cation exchange capacity, and percent base saturation).

VI. Analysis

Samples were air dried in a controlled lab environment for 96 hours and then delivered to the UGA Extension East Point office. Once received, results of nutrient density were converted from units of pounds per acre to milligrams per kilogram. According to the University of Florida IFAS Extension, we can convert from pounds per acre to ppm by multiplying the pounds per acre value by a factor of 0.5. This conversion is based on two assumptions: that the root depth / sampling depth is 6 inches, and that the nutrients are in elemental form. Both these assumptions are satisfied based on our sampling procedure and the UGA extension soil test results. Additionally, according to Kansas State University, 1 ppm of a nutrient/contaminant in soil is equal to 1 mg/kg of the contaminant. This data was then analyzed using [what statistical test??] .

Results

Discussion

We found a significant difference in the mean LBC values between the scraped and unscraped groups (using a t-test), but for no other variables. However, this could be a result of our small sample size, in addition to low concentrations of specific elements, such as Molybdenum and Nickel which were too low to determine confidently. When looking at the results, it's clear that OG2 is an outlier within the unscraped samples and within the samples as a whole. Even upon visual inspection, OG2 was slightly darker and had a different texture. The most marked differences were comparatively lower Iron (Fe) and Copper (Cu) concentrations, and higher Phosphorous (P), Magnesium (Mg), and Calcium (Ca) concentrations. Except for iron, each of these indicators seems to point toward a higher organic matter content; however, we still need to complete an organic matter analysis to know for certain. The incongruity of OG2 may be explained by taking a closer look at the historical landscape of the Eco-Commons area as shown in Figure 5. When the area was still a parking lot, we intended for OG sites 1-3 to lie in the minimally disturbed green area; however, OG1 was originally in the asphalt area and OG3 was along the border between the asphalt and green area. Therefore, it is possible that only OG2 was a true "unscraped" site or was subject to a different remediation protocol. The comparative iron deficiency at OG2 is somewhat more difficult to explain but may be caused by the elevated phosphorus and zinc.

Below are a few sources of error that we identified through testing our procedures:

The core was slightly rusty due to past use, so we opted to use a PVC punch-out tool (Fig. 2) to collect soil from within the core while avoiding contact with the metal. This lacked precision, possibly resulting in an uneven distribution of the soil layers.

Each sample contained the minimum required amount of soil as designated by the UGA Extension Service. As such, we could not sort some organic matter (roots, debris, etc.) and larger sediments out of the samples before analysis.

Many of our randomly distributed sampling sites were inaccessible for sampling, resulting in a few of the sites being clustered together.

Future Work

Moving forward, we plan to achieve our objective of measuring the current soil health of the Eco-Commons by:

Collecting another round of soil samples that will be used for both geochemical and biological analysis.

Conducting plant surveys around sampling points to analyze the relationship between soil communities and plant communities.

Developing a sustainable methodology to conduct geochemical analyses on-campus and comparing the accuracy of those results with the UGA extension services.

We will also conduct activities aimed at restoring and preserving the soil health in the long term by:

Comparing our results to a less disturbed Piedmont environment and devising proposals for potential soil amendments to help the Eco-Commons soils reach desired goals.

Establishing long-term protocols to monitor changes in soil health either through the VIP program or through relevant labs on campus.

The Team!

References